Test and Electronics

7 mm Verification Kit. Kit includes a set of 7 mm measured standards used to verify the performance of an HP 8510 series network analyzer operating with error correction. Option 010.

3.5 mm Verification Kit. Set of precision devices with data used to verify the error corrected performance of the HP 8510 system.

3.5 mm Calibration Kit. Used to calibrate Agilent network analyzers up to 6 GHz for measurements of components with 3.5 mm connectors. Option 010.

Baseband, IF and RF Network Analyzer 5 Hz to 500 MHz. 5 Hz to 500 MHz. +/-0.02 dB, +/-0.12deg. dynamic accuracy. 0.001 Hz, 0.001 dB, 0.001 degree, 10 ps resolution. Full 2-port and interpolative calibration. Conjugate matching analysis. 10 updates of 201 sweep points per second. 0.4ms/point fast list sweep (IFBW = 4 kHz). Up to 4 traces simultaneous measurement/display.

Fiber Optic Interferometer. This is an accessory to the HP 71400C, 71401C or 83810A lightwave signal analyzers. It uses a self-homodyne technique to convert optical phase or frequency deviations into intensity variations. Opt. 012 FC/PC connector interface.

50 GHz Synthesized Swept CW Generator with Opt. 001, 008. Frequency Range: 10 MHz to 50 GHz. Includes option 001 and 008. Option 001: Adds step attentuator. Minimal set table output power -110 dBM. Maximum is reduced by 1.5 dB to 20 GHz, 2 dB above 20 GHz and 2.5 dB above 40 GHz. Option 008: 1 Hz frequency resolution. CE marked.

Tunable Laser Source 1470 nm to 1580 nm. For characterizing and testing optical amplifiers and components. Wavelength Range: 1470 nm to 1580 nm. Wavelength Accuracy: Less than +/-0.1 nm. Tuning Speed: 200 ms. Max. Output Power: +2.5 dB.

Precision Fiber Optic Source. Output wavelength 1550 nm. Minimum output power of 1 mw. Power adjustable over a dynamic range greater than 10 dB. Internal modulation at 270, 1000 and 2000 Hz. GPIB programmable.

Precision Fiber Optic Source. Output wavelength 1550 nm. DFB suffix indicates narrow beam width. Min output power of 1 mW into a single mode fiber. Power adjustable over a dynamic range of greater than 10 dB. Internal modulation at 270,1000 and 2000 Hz. GPIB programmable.

1.5A 9W Laser Diode Controller Module. Output Current Range: 0 to 1500 mA. Used in the LDC 3916 16 channel diode controller. 2 Available.